Depends on your supply voltage.
If the supply Voltage is 12V
12V - 5V(voltage of the LED) = 7V
7V / 1.05A = 6.6 Ohm
Resistor has to be rated 7V*1.05A= 7.35W minimum.
-> use a LED Driver, either buck or boost depending on your application.
A resistor is not a good option for high power LEDs.
Yeah 450W is correct for the XSW-30.
Pure Xenon Lamps give a very good CRI and are immediately at full brightness after igniting, they are however quite inefficient.
In the range of 25lm/Watt I believe.
UHP / UltraHighPressure / UltraHighPerformance lamps only use mercury as far as I know.
They...
Im mowing with a cheap battery mower I bought for parts only.
With two hoverboard wheels i converted it to RC control.
Baterry used are 16S 10Ah Headway LiFePo4.
That is certainly true but it is no different on a dedicated genset.
You have some amount of fuel consumption for just running the engine and then the additional consumption for added load.
Idling modern car engines often enough does not consume more fuel idling than a carburetor genset.
There...
A modern idling car engine is not that bad with the fuel consumption.
Some 2 Liter engines might be able to run with only 0.16gal/hr of gasoline without load.
This will be close to a 2000W gasoline generator with a carburetor.
With load this will of course increase but thats the case for both...
A zoomed in view:
The bales are about 6m wide, total beam with is about twice that so 12m.
With a distance of 1070m this gives a divergence of 0.65°
The next day I checked the bales for damage, but they are still fine:
While at that place I was looking for the next target.
A wind turbine...
Hello,
I'm Alexander from Germany and new at the forum.
For quite some time I was reading here without a Account.
Im especially interested in spotlights and unusual equipment.
Besides some custom HID builds I have a AEG XSW 30 Searchlight aswell.
Here I wanted to present my latest build, it is...