Recent content by feedramp
-
F
Sold/Expired WTB: Drop-in for Craftsman LED Flashlight
Thanks for looking brother.- feedramp
- Post #7
- Forum: Sold/Expired/Completed
-
F
Sold/Expired WTB: Drop-in for Craftsman LED Flashlight
Drop-in is black plastic with reflector attached via 2 screws that pass through base. Diameter of drop-in is 52.75 mm. Reflector is 57.65 mm and has two flat sides.- feedramp
- Post #5
- Forum: Sold/Expired/Completed
-
F
Sold/Expired WTB: Drop-in for Craftsman LED Flashlight
Used the original drop-in for a project a few years ago. Would like to return old dependable to its original state.- feedramp
- Post #4
- Forum: Sold/Expired/Completed
-
F
Sold/Expired WTB: Drop-in for Craftsman LED Flashlight
Need complete drop-in (w/reflector) for Craftsman Endurable 3 D LED flashlight, model 41-5830. I'm wishing myself luck!- feedramp
- Thread
- Replies: 6
- Forum: Sold/Expired/Completed
-
F
So long Photobucket
Re: Heads-Up if you use Photobucket Look fast! You'll be bombarded with ads and dozens of cookies within seconds! -
F
So long Photobucket
Heads-Up if you use Photobucket If you use Photobucket, images in your posts may look like this: Don't know why this started happening, but noticed it in: http://www.candlepowerforums.com/vb/showthread.php?273724-Surefire-P60-fitment-in-Solarforce-L2 -
F
Surefire P60 fitment in Solarforce L2
Solarforce L2 with "External Tooth Lock Washer" installed:- feedramp
- Post #15
- Forum: General Flashlight Discussion
-
F
Surefire P60 fitment in Solarforce L2
This "External Tooth Lock Washer" works perfectly. It rests on the shelf of the L2 without any play, and the center hole is large enough to keep the P60's inner spring from shorting. A) OD = 22.5 mm B) ID = 13.2 mm C) Thick = 1.75 mm (thinner is ok) Still looking for suggestions on what type...- feedramp
- Post #11
- Forum: General Flashlight Discussion
-
F
Sold/Expired WTB: Insight X2/X2L MTV-750-A1 LED Upgrade Kit
Bump...- feedramp
- Post #2
- Forum: Sold/Expired/Completed
-
F
Surefire P60 fitment in Solarforce L2
I need to make the same mod. I have a stainless steel and copper washer on-hand that both fit well. Any suggestions on which one to use? I am wondering if either will cause some type of corrosive reaction with the L2 body. Thanks- feedramp
- Post #7
- Forum: General Flashlight Discussion
-
F
Sold/Expired WTB: Insight X2/X2L MTV-750-A1 LED Upgrade Kit
I know these are hard to come by, but I'm hoping for some good news. Thanks- feedramp
- Thread
- Replies: 1
- Forum: Sold/Expired/Completed
