Just to share, the BK Precision 389A "Test Bench" Multimeter calibration procedure and multimeter schematics:
https://www.scribd.com/document/385436040/BK-Precision-389A-Multimeter-Calibration-Procedure
https://www.scribd.com/document/385436160/BK-Precision-389A-Multimeter-Schematics...
Holy Cr*p! I think this was it. My issue so far resolved , can't make it acting up any more. Thanks sld, you're a life saver! :thumbsup:
I just change the "copper tabs" on the knob, the inside ones to the outside, then BAM! No more weird behavior anymore. I guess the meter got squished during...
"squeezing the meter from top back near the range knob"
There seem to be some improvement when I do this. Thanks for the tip.
I've put in some 3M foam tape between the selection buttons to see if it helps. I'll update you guys within these 2 days.
I guess you're right parametrek , This multimeter is done, Thanks for the input. :)
Tried insulating the foil EM shield at the back , but still same problem persist . :thumbsdow
I' ll just refer to the manufacturer to see if they got a reply that's other than "please send in to the nearest...
Alas, the most dreadful answer. Been trying to troubleshoot like crazy. Right now the only thing i know is i can reset the meter by reinserting the large fuse or pressing some random sequence of buttons until it dissapears. What i suspect right now is some kind of parasitic leak happening at the...
My multimeter works fine 70 percent of the time. But at random will show a gradually decreasing or increasing voltage and slowly change. Here's the video link:
https://youtu.be/2HN7vMbdrX8
Happens at random. Maybe every 2 days or so. Tried replacing battery, the small...
I'm not a electronics person but from what I gather this is 3.3 ohm +-5% rated resistor?
I blew my sanyo charger NC-MQR06W by stuffing bad battery that it refuse to charge 20 times, it just had enough and decided to blow up.:oops:
I'm going to the electronic part store to see if they...