Recent content by MikeC

fenix-store
  1. M

    Shotgun fore end light

    I looked on the Malkoff site but could not find the spacer you referred to. Do you have a link?
  2. M

    Shotgun fore end light

    I also disagree. Target ID is critical obviously. But, details like what's in his hands, other threats a few feet or yards behind, environment, vehicles etc. are also important. Thanx for the recommendation.
  3. M

    Shotgun fore end light

    I did not know about the spacer. It is an LP foreend. It only has the tape switch. Malkoff has suggested replacing with one of these: https://malkoffdevices.com/collections/surefire-forend-upgrades However they are out of stock. Thanx for the ID. I will look for z32 LED replacements. Any...
  4. M

    Shotgun fore end light

    I have a pump gun with a Laser Products fore end that has a screw-in light in it. It has a finger activated tape switch on the right side. Looks like a 6p clone and runs on 2x123. The bulb is a laser products incan, 6V, P60, says NJ-1 on it also. It has two nested springs. I would like to...
  5. M

    Weapon light discussion, (loosely) related topics welcome

    Your case prep chamfer should take care of this.
  6. M

    Battery basics

    This is helpful, I did fail to take sag (voltage drop under load) into account. BUT, I don't see a curve showing 2xCR123 drop vs. the 16650. ITSM that 2xCR123 starts with a higher voltage and has more "room" to drop. OTOH a single rechargeable cell is more attractive than feeding CR123 batteries.
  7. M

    Battery basics

    6P runs on [email protected] ea= 7.4v. Why/how can we run 16650 which is rated at 3.7v? What am I missing?
See more

Latest posts

Top