Now I can't use the Q5 for some reasons and changing it to a Seoul SSC P4 and attaching the LED base to the combo heatsink/driver unit using normal epoxy and driving current is 950ma at 3V. The distance between the heat sink and SSC P4 led is 0.42mm. Will there be any heat issues?
I don't want to spend money on AA heat epoxy for one Cree emitter. I was thinking to use normal resin epoxy to hold it in place to a heat sink. A very thin layer will be applied. It will be driven to 890ma at 3V using two AA rechargable batteries. Will there be heat issues?
Thanks
After boring the 2D Mag host
The batteries
No more limited to low capacity rechargable or alkalines. Now using 8x 2700mah. Woohoo!! The best part is I can just push in the battery holder in any orientation.:p