Is there anyway You can do pic or two of the Gold plate
with the head off? I may have to chomp down on this one.
Come on Lux break out them crayolas man. :poke:
starburst
Re: when will Malkoff update their dropins?
I have three Q5's behind optics, but still use my m60 Q2/reflector!!
If Gene hits the beam and tint of the older Q2 reflector design you will
love it. With a R5/reflector I can see a lot of Q5/optics on break.
I been waitin for this baby!! :twothumbs
My favorite 2D Alkaline setup is using a 500ma micropuck with
a single led it will run for days!!!
Welcome! mdh32276 :wave:
Try Odd Mods in the custom B/S/T section.
The Q5 early model I have has worked flawlessly.
Is there anywhere to get another one? I went to
4 Sevens, said out of stock and no back order.
starburst
:paypal: for one B version softstart switch for Megalennium $49
for 3 x protected 18650 $36
for 3 x protected RCR123 $18
for registered shipping $7.50
Total $110.50
starburst
Same here, but mine was a rebel its not exactly the same tint as the
other three ( flood light with 4 rebels ) but I have to look over in the
edge of the light to tell which one it was. At least its not royal blue
now like without the dome.
Starburst,
Question's about charging/using A123 in series
I took apart a Dewalt tool pack and left some of the cells in pairs
with the factory welded tabs still in place. will they charge up
properly in pairs like this?
I'm runing 2s-2p in a 4D Mg with a ROP High wired together with
16 Gauge wire will...
Re: 2 different Cree Q5 LEDS?
My Nitecore is silver, as You have, I've seen both color's not 100% but,
I think it's something to do with the way they apply the yellow phosphur
other's I'm sure can give You a more complete answer.
The silver based Cree's I have seen have been pretty cold...