Recent content by TailoredEDC

fenix-store
  1. T

    Source for 10mm clicky switch

    Thanks alot for the tips. Switches ordered :)
  2. T

    Source for 10mm clicky switch

    Im currently working on a 10440 light, but I havent found a 10mm clicky. Any suggestions? Also need a 10 or 12mm booth. Will be very greatfull for help :)
  3. T

    Sold/Expired FS: Mockbug. First small series run

    I will take number 10 :) Standard firmware.
  4. T

    Introducing Mockbug: The story of my first flashlight build.

    Wow this looks very good! Brass is very nice to work with! It is actually the standard of how good a material is to machine with brass as the best machining of them all. Im still tinkering with my design unfortunately, but Im finding great inspiration in your project. Just need to finish a...
  5. T

    CRX Hand Made Flashlights & Stuff

    Simply AMAZING! It has to be the most incredible post on this forum! Well done sir!!!!:twothumbs
  6. T

    Introducing Mockbug: The story of my first flashlight build.

    I see your time consuming work was not to finish it, but to get the correct size. My bad! I thought it was to remove the scratches.
  7. T

    Introducing Mockbug: The story of my first flashlight build.

    Really Nice to hear you are still cranking on! When removing tool marks I use a ocillating sander og the type use for general sanding. I have a Hitachi With 125mm diameter round sanding pad and I use 400grit. Just be careful on edges since it will round them if you apply too much pressure. Take...
  8. T

    Introducing Mockbug: The story of my first flashlight build.

    Looking good!! If you want I can cerakote one for you in Midnight bronze :)
  9. T

    Titanium wire for flashlight clip

    Thanks for your input Mcbrat! Love the finish on your clips!
  10. T

    Introducing Mockbug: The story of my first flashlight build.

    Thanks for the advice! Im hoping to have something to show in not too long. Currently hamstering materials. so many choices!! I work with and also make custom design lighting for a living. Looking at venturing alittle more over to EDC, but designing and prototyping is a slow project that...
  11. T

    Titanium wire for flashlight clip

    Great! Do you bend them aswell? I have understood that the bending of grade 5 is not the easiest task. Do you apply heat or is it cold bent? If you have some pictures or a link to your products that would be greatly appreciated!
  12. T

    Titanium wire for flashlight clip

    Thanks for the imput! So you make wireclips in grade5 or flat clips to replace the original?
  13. T

    Driver and battery recommendations for Oslon square

    Hello Im planning on making my first scratch built flashlight and I want a high CRI Single Osram Oslon powered flashlight with warm light. Looking at batteries the 14650 looks interesting, but Im also looking at the 10440 for a slimmer flashlight. Any thoughts on this? The total length of the...
  14. T

    Introducing Mockbug: The story of my first flashlight build.

    Great to see some progress :D Really looking forward to your next update! How does your toolchanger give you problems? Sometimes discussing the symptoms with others can give another angle of potentials sources for the problem. Im still drawing models in fusion of my first flashlight. I want it...
  15. T

    Introducing Mockbug: The story of my first flashlight build.

    Looks awesome! You could look into a 4 jaw chuck instead. then you could make sure it runs true even it the chuck is cheap. a 5c COLLET INDEXER could be perfect for you. Kep up the good work! Dont give up!
See more

Latest posts

Top