• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired Mag D Incan Driver - Soft Start & Multi-Brightness

AW

Newly Enlightened
Joined
Oct 15, 2004
Messages
33
Location
Hong Kong
Not Available - Mag D Incan Driver - Soft Start & Multi-Brightness

Introducing the Mag D Incan Driver with soft starting feature, 3 brightness settings and flashing mode. This driver assembly is a complete drop-in to replace the stock Mag D switch. The all metal switch housing is built with a high temp. KIU bi-pin socket and the driver board enclosed within. Great for running hotwire super bulbs for up to 150W ( 200W intermittent use ). Input voltage can be as high as 30V ( max. pack open voltage ). Runtime can be extended according to your brightness setting. ( Note : This driver does not have output voltage regulation yet ).

Specifications:

- Soft Starting to prolong bulb life and ease the amperage draw on the batteries during power up;
- 3 brightness level ( PWM controlled ) - 30% - 60% - 100%;
- Last brightness setting memory ( default level - 30% );
- Flashing mode;
- Simple UI ( click - ON ( low ) - Med - High - click & hold anytime - OFF - click & hold 1.5 seconds - Flashing );
- Input voltage from 6V - 30V Max. open voltage ( Vin = Vout );
- Drive bi-pin hotwire bulbs up to 150W ( 200W intermittent use );
- Full alum./brass housing to withstand heat and better heat sinking;
- Power efficiency 99%;
- slightly recessed push button to prevent accidental power on;
- comes with 10mm, 15mm, 20mm brass posts and washers for different height bulbs.


Here is couple video clips of how the driver works :

Incan Smart Driver Video Clip 1


Incan Smart Driver Video clip 2


Special Notes :

1) Works with both cam and camless reflector
2) No Soft start for ' Flashing Mode '
3) The PCB mount push button has no momentary
4) Alum. reflector and glass lens required
5) Standby power drain of the circuit is approx. 80uA
6) Total internal resistance is < 30mOhm ( according to data sheets of components ).
7). Do not press the button switch too hard, a slight press will operate all the functions.





P1010029.jpg


P1010026.jpg


P1010024.jpg





Installation is simple. Remove the stock switch with a hex key ( 2mm ) and slide it out from the rear




Insert the Driver Switch in and align the switch button to the center. Use the same hex key to tighten the hex screw. You may want to move back and forth a couple times on the last turn to make sure the screw pierce through the anodizing for a good contact








Price : $75.00 each ( ALL SOLD)

Shipping : $6.00 by Registered Mail


PayPal : [email protected]
 
Last edited:

AW

Newly Enlightened
Joined
Oct 15, 2004
Messages
33
Location
Hong Kong
The socket wires are soldered to the circuit board and you don't need to do anything about them. To replace posts with different length, you only need to unscrew the M3 screws on the socket and unscrew the posts. Replace with different length posts / spacers and that's it.

:drool: Wow.

Does the copper colored plate that the posts attach to unscrew so the socket wires can be soldered and unsoldered?
 

Nebula

Enlightened
Joined
Sep 9, 2006
Messages
993
Location
Northern Virginia
AW- I will take 1. PP shortly. Thanks sooooooo much for bringing these to market. I look forward to the regulated version.

Kirk

Edit: AW - :paypal: for Soft starter and a few extras. Thanks. Kirk
 
Last edited:

LuxLuthor

Flashaholic
Joined
Nov 5, 2005
Messages
10,653
Location
MS
AW, thanks for an early Christmas present. I have many uses for these, as well as the regulated version, and wanted to thank you for all your testing and feedback with these!

2 Drivers $158 sent!

AW.gif
:paypal:
AW.gif
 
Last edited:

DMC

Newly Enlightened
Joined
Nov 11, 2006
Messages
175
Location
Austin
Paypal from DMC sent for:

2 Mag D Incan Driver - $150.00
Shipping - $ 7.50
----------------------------------
Total - $157.50


Thanks AW!:goodjob:
 

David1

Newly Enlightened
Joined
Feb 6, 2006
Messages
83
Location
Mesa, Arizona
I will take one, paypal coming!

:paypal: for $81.00.

Thanks for doing these. What is the timeline for the regulated version?
 
Last edited:

nitere

Newly Enlightened
Joined
Feb 28, 2007
Messages
64
I have been waiting for a long time for this, thanks AW!

2 Mag D Incan Driver - $150.00
Shipping - $ 7.50
__________________________

Total - $157.50

:paypal:
 
Top