Unknown Aleph pill driver

Genna · Mar 19, 2016

Hello all, after a while I forget the specs from this driver. It's on a Aleph pill with XP-G (I suppose) and it's from Arcmania/Mike Jordan.
I need the Amperage/Volt and if possible to reset/programming the firmware. It's a 3 stage driver, but now in every stage after a few seconds it's start with ramping.

ImageUploadedByCandlepowerforums1458402196.594258.jpg

ImageUploadedByCandlepowerforums1458402212.512215.jpg

Thanks for looking and help!
Genna

mcbrat · Mar 23, 2016

I had a driver do that, and it was in a rest sequence, and since I kept shutting it off to try and figure out what the problem was, it kept in that mode until I finally just turned it on, and let it go through the ramp sequence to reset itself, then after it was done, it was back to normal.

archimedes · Mar 23, 2016

Most likely calibrating ....

Ladd · Mar 23, 2016

It would be interesting to see the other side of the pcb. Wonder whutizzit

Genna · Mar 29, 2016

Thanks, but re-calibrating don't work or don't have this funktion. After ramping to high the light go off and restart with ramping.

Unknown Aleph pill driver

Genna

Flashlight Enthusiast

mcbrat

Flashlight Enthusiast

archimedes

Flashaholic

Ladd

Enlightened

Genna

Flashlight Enthusiast

Similar threads

Latest posts