What driver to use?

Packhorse

Flashlight Enthusiast
Joined
Nov 29, 2007
Messages
1,912
Location
New Zealand
Hi all,
Been out of the game for sometime. But I have a new project in mind.
I want to build a multiple video light head system. Either 2 or 4 light heads.
Total Lumen yet to be decided but lets say anywhere from 20,000 lumen and up.

I have a Cuda 400 DPV with a 12S7P liIon battery pack (1000wh) and have a EO wet mateable plug (2 pin) in the scooter so I can access the pack.

What drivers could I use? My options could be to run all light heads from a single driver or a driver in each light head.

I could also use a voltage regulator inside the scooter to drop the voltage down ( I Have no idea what voltahe the EO's are rated at) but I think the current may end up being to great.

Anyone with any thoughts on the matter?
 

DIWdiver

Flashlight Enthusiast
Joined
Jan 27, 2010
Messages
2,725
Location
Connecticut, USA
How about the Taskled Hyperboost or Hyperbuck? Even straight off a hot charge, they can handle the input voltage (well, you'd be 0.2V over for a short time). You might need 2 or 3 to get the power you want.
 

Packhorse

Flashlight Enthusiast
Joined
Nov 29, 2007
Messages
1,912
Location
New Zealand
How about the Taskled Hyperboost or Hyperbuck? Even straight off a hot charge, they can handle the input voltage ( well, you'd be 0.2V over for a short time). You might need 2 or 3 to get the power you want.


The hyperbuck would be the go,but its dicontinued by the look
 
Top