Over the years, i have etched and build many PCBs, some at home, some i ordered in different parts of the world.
The whole process with FR4 is not new to me, but i have never ordered MPCBs, but i have done some reading.
Besides staying within the design rules of the PCB manufacturer, are there things to consider that are different from normal PCBs?
The board is very, very simple.
Those are two different versions, one just has a bunch of holes along the perimeter for some crazy reasons, i just removed all the silkscreen on the bottom ones so you can see the copper better.
http://i.imgur.com/yxpmdIF.png
Not much on there besides a 0805 NTC, four pads and the footprint for three LEDs.
At the moment i am a bit unsure if which version i want to order but that is all on me.
The PCB will only be populated with one or two LEDs, never all three.
The other footprints will be just shorted out with some wire in that case.
Anything in particular i should look out for?
The whole process with FR4 is not new to me, but i have never ordered MPCBs, but i have done some reading.
Besides staying within the design rules of the PCB manufacturer, are there things to consider that are different from normal PCBs?
The board is very, very simple.
Those are two different versions, one just has a bunch of holes along the perimeter for some crazy reasons, i just removed all the silkscreen on the bottom ones so you can see the copper better.
http://i.imgur.com/yxpmdIF.png
Not much on there besides a 0805 NTC, four pads and the footprint for three LEDs.
At the moment i am a bit unsure if which version i want to order but that is all on me.
The PCB will only be populated with one or two LEDs, never all three.
The other footprints will be just shorted out with some wire in that case.
Anything in particular i should look out for?