Weird 1-10v LED strip dimming issue

Wind

Newly Enlightened
Joined
Mar 21, 2018
Messages
1
Hi all

Recently i've encountered some weird case in relate to LED strip dimming, a summery of the case as below:-

1) LED Strip installed inside a decorative lighting

2) Runs on Lutron 1-10v dimming signal

3) One section of LED strip starts to flicker only after its adjusted to 50%

4) Swap that section of LED strip to other proper working module's driver, problem remain the same

problem is, theres a flicker at the output voltage causing the flicker, when i wire the load to any other driver, when other load works perfectly fine

Wonder if anyone encounter this before?
 

ssanasisredna

Enlightened
Joined
Oct 19, 2016
Messages
457
Hi all

Recently i've encountered some weird case in relate to LED strip dimming, a summery of the case as below:-

1) LED Strip installed inside a decorative lighting

2) Runs on Lutron 1-10v dimming signal

3) One section of LED strip starts to flicker only after its adjusted to 50%

4) Swap that section of LED strip to other proper working module's driver, problem remain the same

problem is, theres a flicker at the output voltage causing the flicker, when i wire the load to any other driver, when other load works perfectly fine

Wonder if anyone encounter this before?

Without knowing anything about the strips you are using, the drivers, etc. it is impossible to make any informed comment.
 
Top