Fenix PD40 stuck on Low setting

Accountant99x

Newly Enlightened
Joined
Jun 27, 2018
Messages
1
Everything worked perfectly until today.


Now when I turn it on I'm put in LOW mode. When I try to change mode (quick press of button) it blinks like it would change mode but it stays in same mode. And every attempt to change mode after that first one does nothing, not even that first blink.


At first I thought battery is low and that was reason it is stuck in low mode. But after recharging battery to full problem stays the same. (I have tried putting in different batteries, still the same problem)


And I can enter that TURBO mode (1600 lumen) by holding button pressed. No problem there.


Is there anything I can do? (I really liked this one :( )


Thank you
 

colight

Enlightened
Joined
Dec 6, 2013
Messages
304
Location
On Earth
Accountant, as far as I can remember the PD40R is not such an old release (around 2016?), so you will still be covered by Fenix's warranty. Even the original PD40 should still be covered. If possible, just return it to where you bought it for advice.
 
Top