F89
Flashlight Enthusiast
- Joined
- Mar 15, 2014
- Messages
- 1,420
I'm looking at building a quad p60 and was hoping to gain some insight.
Will be parallel and using a fet plus 7135 driver (likely a H17Fx).
I understand that a lower vf LED on the board will work harder but how much will it really matter if I've got a bunch of LEDs binned the same? Obviously there'll be some variation to spec.
I've noticed some builders like Tana mention they vf match LEDs in their builds. Is there an easy way to individually test LEDs for the build with minimum fuss?
Advice and info appreciated.
Will be parallel and using a fet plus 7135 driver (likely a H17Fx).
I understand that a lower vf LED on the board will work harder but how much will it really matter if I've got a bunch of LEDs binned the same? Obviously there'll be some variation to spec.
I've noticed some builders like Tana mention they vf match LEDs in their builds. Is there an easy way to individually test LEDs for the build with minimum fuss?
Advice and info appreciated.