First up, a No-Name Stainless Steel flashlight with DIY setup.
Features the following:
Note: Switch can be a bit finicky, but never bothered me enough to mess with it. Always works.
Bought from fellow CPF'er.
Asking $85 NOW $65 delivered..SOLD
Sold, Thanks CPF!
2nd up is a Copperhead made by CPF's own "Schizeckinosy". (SOLD)
* Smooth Bezel
* Optic-FOV 45*
* XML2 5K
* KD 3050 50ma low
* L-M-H No Memory
* Foward McClickie Cap
* Completely potted, heavy duty wiring, damn near indestructible.
* Designed for so you can add an extra 123 tube for fitting a 18650, so just a 123 battery is a bit loose, I used a rolled up $1 bill as sleeve. (not included..LOL)
I bought this from the original CPF owner. Has a very nice patina built up, easily removed with Ketchup or lemon juice. Small ding in copper edge where a bezel would be, but no bezel on this light. Visible in second photo. Doesn't have any effect, very small.
Asking $60 delivered. (SOLD)
First "I'll take it" in post, snags the light. Followed by prompt payment please.
Paypal G&S, I eat the fees.
Shipping free to CONUS via USPS.
PM any questions.
Thanks for looking.
Features the following:
- SS host with deep OP reflector and reverse clicky switch.
- XM-L2 T5-5C1 4000K LED on copper mPCB.
- Mtn Electronics 17mm FET Direct Drive driver with 60 second Turbo step-down (ie: drops from 100% to 50% after 60 seconds).
- Levels: 2%, 5%, 20%, 50%, 100%
- Fits a 65mm unprotected 18650 battery. Switch can be unscrewed a bit to fit a longer protected cell but the button will stick out the back and it won't be able to tailstand.
Note: Switch can be a bit finicky, but never bothered me enough to mess with it. Always works.
Bought from fellow CPF'er.
Asking $85 NOW $65 delivered..SOLD
Sold, Thanks CPF!
2nd up is a Copperhead made by CPF's own "Schizeckinosy". (SOLD)
* Smooth Bezel
* Optic-FOV 45*
* XML2 5K
* KD 3050 50ma low
* L-M-H No Memory
* Foward McClickie Cap
* Completely potted, heavy duty wiring, damn near indestructible.
* Designed for so you can add an extra 123 tube for fitting a 18650, so just a 123 battery is a bit loose, I used a rolled up $1 bill as sleeve. (not included..LOL)
I bought this from the original CPF owner. Has a very nice patina built up, easily removed with Ketchup or lemon juice. Small ding in copper edge where a bezel would be, but no bezel on this light. Visible in second photo. Doesn't have any effect, very small.
Asking $60 delivered. (SOLD)
First "I'll take it" in post, snags the light. Followed by prompt payment please.
Paypal G&S, I eat the fees.
Shipping free to CONUS via USPS.
PM any questions.
Thanks for looking.
Attachments
Last edited: