Capolini
Banned
Thanks again SB for ALL your help!
I tested again last night to see if the RED light would come on when voltage got low. It did not. Did the same thing as it did on the trail which is the LED was OFF completely in all modes until I deactivated, reactivated and then it only works in L/M/H! I do not think I mentioned this in my previous posts. On the trail,,,turbo still worked at this point. Last night when the LED indicator went off the light simultaneously stepped down,,,most likely to HIGH.
So, my thoughts are as follows. If the LOW voltage LED indicator does not work, how could I be sure if the if the following is true for my light??,,,,, "The TN36 has over-discharge protection built into the light's circuit." I am not confident it will and have no way of knowing at this moment.
The reason that is important is because my K'Powers are very tight. I have to be careful I do not rip the wrapper or cut the tip of my finger as I slide them in! So, I am most likely going to get NCR18650B 3400mAh "UNPROTECTED" Button tops and use the K'powers for my TK61vn where I know they will fit much better.
With that said I would want the over discharge protection that is built into the light to work!
I really like the light and will work this out w/ Illumns who are always a pleasure to do business with! I may just have to wait because of the difficulty to get these lights right now!
I tested again last night to see if the RED light would come on when voltage got low. It did not. Did the same thing as it did on the trail which is the LED was OFF completely in all modes until I deactivated, reactivated and then it only works in L/M/H! I do not think I mentioned this in my previous posts. On the trail,,,turbo still worked at this point. Last night when the LED indicator went off the light simultaneously stepped down,,,most likely to HIGH.
So, my thoughts are as follows. If the LOW voltage LED indicator does not work, how could I be sure if the if the following is true for my light??,,,,, "The TN36 has over-discharge protection built into the light's circuit." I am not confident it will and have no way of knowing at this moment.
The reason that is important is because my K'Powers are very tight. I have to be careful I do not rip the wrapper or cut the tip of my finger as I slide them in! So, I am most likely going to get NCR18650B 3400mAh "UNPROTECTED" Button tops and use the K'powers for my TK61vn where I know they will fit much better.
With that said I would want the over discharge protection that is built into the light to work!
I really like the light and will work this out w/ Illumns who are always a pleasure to do business with! I may just have to wait because of the difficulty to get these lights right now!