Recent content by Kryosphinx

fenix-store
  1. Kryosphinx

    forum Newbie>>engineering student with projects

    2nd year MSOE ME student here! Just and FYI, when you apply for internships and such, tell em that you do this stuff. They like high-tech flashlight mods. :D
  2. Kryosphinx

    Sold/Expired WTB: A couple AMC7135 1400mA

    I need a few of these, but seeing as DX is having some sort of difficulty with them, I thought I'd try here. Lemme know if you have a few spares! Thanks a lot!
  3. Kryosphinx

    Sold/Expired FS: Microprocessor controlled drivers

    Re: Microprocessor controlled 4-mode driver boards - 1AA boards on sale! I'm interested in one of the next version of the AA board with strobe.
  4. Kryosphinx

    KL1 Gen4...Freeze Pop?

    It you get the front out first, there are notches you can stick some needlenose pliers into to twist. If you get the back out first, make sure you don't put any torque on the converter board. What I did was to remove the converter board and then I cut a US quarter in half and slipped it into...
  5. Kryosphinx

    Which reflectors or optics for a quad-thrower?

    27mm IMS reflectors aren't going to fit. One will fit, there's no chance of you getting four in there.
  6. Kryosphinx

    Boogered up a KL1 Mod - Need ideas

    IIRC, the old style head fit IMS17 sized optics/reflectors. If that's the case, then the McR20R-S is far too big. It fits in a new style (KL4-ish) KL1 just fine. As for the tightening issue, maybe a bad solder joint?? It's hard to diagnose without pics, though you gave a fairly detailed...
  7. Kryosphinx

    Sold/Expired FS Aborted M@G Cree project

    PM sent
  8. Kryosphinx

    Sold/Expired SOLD!Mclux 27LT XR-E $150,Z49 Tailcap,Detonator,Ti,SS,Al Bezels,McE2s Boards and SMJ

    Re: 9 Bezel`s $55 Shipped & 6x Uncut SMJ Leds $Free!! Shipped! I'll take the free MJLEDS
  9. Kryosphinx

    What else do you collect?

    Fountain pens
  10. Kryosphinx

    Seoul P4 initial Evaluation- Production LEDs

    Has anyone tried a P4 with an IMS20?
  11. Kryosphinx

    Who wants a shoot at modding a....

    Give it to 3rd. He's a cleaner/neater modder than I. :)
  12. Kryosphinx

    Who wants a shoot at modding a....

    I'll do it! Did you want it back when I finished?
  13. Kryosphinx

    Machinist/Latheperson needed

    That's correct, I just need the PXR raised .3125"
  14. Kryosphinx

    Machinist/Latheperson needed

    I considered that before, but discarded the idea for some reason. I think I wanted maximum heatsinking capability for running the light at full blast continuously. Threading should have more surface area to transfer heat. Do you think that a spacer would provide sufficient heatsinking? It...
  15. Kryosphinx

    Machinist/Latheperson needed

    First post updated. Hope the pics clear up the confusion. MM, I'm awaiting your reply.
See more

Latest posts

Top