Recent content by Wyvern

fenix-store
  1. Wyvern

    where to find checked 5mW leadlight 110's?

    Re: where to find checked 5mW leadlight 110\'s? Also the leadlight 110's are much easier to mod than the 105's with a generaly more consistant higher output
  2. Wyvern

    Safe way to short the pot?

    So if we do your mod and get the laser up to 45mW can we then do then do the resistor mods etc it will be even more powerful?
  3. Wyvern

    PCB Printing

    i too am interested
  4. Wyvern

    new leadlight 110 mod!!!

    yes my led did glow dimmer (i think it was ready to blow) but i feel an led is a waste of mA so i got rid of that too i still have the photodiode in place and seems to make no difference, it seems we were initialy wrong in thinking it was there to limit the beam to 5mW i do have a rough...
  5. Wyvern

    new leadlight 110 mod!!!

    thats the one, i assumed it was a diode because of the line but because of the size it may well be a cap
  6. Wyvern

    new leadlight 110 mod!!!

    try it and see!! first do the pot mod then short the 102 resistor described on another thread then short the diode dont ask me how it works but it does
  7. Wyvern

    new leadlight 110 mod!!!

    i can now easily burn through black electrical tape within 2-3 seconds, i have no way of measuring the power can anyone estimate?
  8. Wyvern

    new leadlight 110 mod!!!

    to everyone who has a 110 here: do the "102" resistor mod then short the diode labled A106 on the opposite side of the board, i got about 10mw extra this way Enjoy
  9. Wyvern

    PCB Printing

    here we go 350 x 275mm of circuit area maximum of 50 circuits £158.63
  10. Wyvern

    PCB Printing

    from what i understand they have a standard board size and fixed price so you can actually have the same circuit printed over and over again until they fill up the board
  11. Wyvern

    New diode,new MCA set, how hard? results?

    try New page if you want things done properly you have to host it yourself!!!
  12. Wyvern

    PCB Printing

    I have found a company near me who print pcb's and if someone could re-design the driverboard for a leadlight i could get a load done, it shouldnt be so expensive if we all chip in on it. then we all get the benefits
  13. Wyvern

    New diode,new MCA set, how hard? results?

    [ QUOTE ] Arni said: With a 1 Ohm resistor parallel to the original 0,4 the diode form ifix...(Gastrapped) can take 720mA. No shorting the pot. Just tryed out a normal Diode: at 630mA output 808nm 536mWatt [/ QUOTE ] could you post some detailed instructions of what to do to the driver board
  14. Wyvern

    New diode,new MCA set, how hard? results?

    will the diodes from ifixlasers take 650ma (shorting the pot)? also i have heard that the standard diodes are 350-400mw anyway!! can anyone confirm this?
  15. Wyvern

    Thinking of playing with the big boys

    but as long as u r careful it should be ok i have AS5 on my diode + all places in the barrell and it hasnt caused any problems
See more

Latest posts

Top