Thanks, guys.
I am not quite done yet, I don't want to do key chain carry & scratch up the one & only Nite D5 Prototype:laughing:.
So I decided to install a Deep Pocket Carry Clip & EDC it that way. Who would want a PD without a clip, right?
But the D10 Clip is way too long, almost the length of the whole light, So I decided to transplant the
Vital Gear FB2 Clip from my E2DL lego, it looked too tiny on the E2DL anyways.
I think it fits much better on the D5:
Due to the split-mount design, I was able to bend it to fit the spacing & curve of this light without problems.
I made sure it's not touching, so no scratches unscrewing the head on & off.
It's pretty stiff, so it holds on my pocket edge pretty secure.
The tiny black screws & brass nuts came out of a used notebook docking station.
I had to grind down both the screw & the nuts to make it fit in the limited space.
The custom brass nuts doesn't look to bad, does it?
I'd like to complete this project with a trit on the piston.
I am looking for a Stock D10 piston, so I can swap out the trit piston from other D10 & cut it down.
It has to be the style with o-ring at the neck. I think there's at least 2 styles of D10 piston,
I am looking for the style below:
Update: Piston Found!
I am not quite done yet, I don't want to do key chain carry & scratch up the one & only Nite D5 Prototype:laughing:.
So I decided to install a Deep Pocket Carry Clip & EDC it that way. Who would want a PD without a clip, right?
But the D10 Clip is way too long, almost the length of the whole light, So I decided to transplant the
Vital Gear FB2 Clip from my E2DL lego, it looked too tiny on the E2DL anyways.
I think it fits much better on the D5:
Due to the split-mount design, I was able to bend it to fit the spacing & curve of this light without problems.
I made sure it's not touching, so no scratches unscrewing the head on & off.
It's pretty stiff, so it holds on my pocket edge pretty secure.
The tiny black screws & brass nuts came out of a used notebook docking station.
I had to grind down both the screw & the nuts to make it fit in the limited space.
The custom brass nuts doesn't look to bad, does it?
I'd like to complete this project with a trit on the piston.
I am looking for a Stock D10 piston, so I can swap out the trit piston from other D10 & cut it down.
It has to be the style with o-ring at the neck. I think there's at least 2 styles of D10 piston,
I am looking for the style below:
Update: Piston Found!
Last edited: