gofastman
Enlightened
I'm trying to setup a solid-state switching device for my coworkers truck winch.
The manual says it can draw a maximum of 335A at full load.
I was planning to use 8 TO-220 mosfets that are rated at 49A each. They will be connected to the A/C evaporator line, so heat shouldn't be an issue.
I'm trying to figure out the best way to connect all of these mosfets little pins to a 2 AWG cable
Perhaps solder them to a copper bar and bolt on the cable with a ring terminal?
The manual says it can draw a maximum of 335A at full load.
I was planning to use 8 TO-220 mosfets that are rated at 49A each. They will be connected to the A/C evaporator line, so heat shouldn't be an issue.
I'm trying to figure out the best way to connect all of these mosfets little pins to a 2 AWG cable
Perhaps solder them to a copper bar and bolt on the cable with a ring terminal?