• You must be a Supporting Member to participate in the Candle Power Forums Marketplace.

    You can become a Supporting Member.

Sold/Expired 100pc Left Titanium Firefly

Gather App
Candle Power Forums

Help Support Candle Power:

Received mine in Australia today. Fantastic light. 219B tint is very nice as expected and top grade machining. Thank you!!!
 
Got mine today in California. Easy to install trits.

Is there a manual somewhere? I'm having some challenges getting it to turn on consistently in the same brightness setting.
 
That would be tomorrow :grin2: or is it July already in your timezone?
.
.
Nice pic, msim...
 
recDNA said:
Are you using li ion? I wonder if it is brighter that way?
Click to expand...

I just did an unscientific test with a AA (Eneloop Pro) and a 14500 Li ion. The Li ion looks noticeably brighter to me. I'm using a protected cell, and it is quite tight. Might have a hunt around for an IMR.
 
lacrimosa said:
I just did an unscientific test with a AA (Eneloop Pro) and a 14500 Li ion. The Li ion looks noticeably brighter to me. I'm using a protected cell, and it is quite tight. Might have a hunt around for an IMR.
Click to expand...
Thanks for the quick reply! How was heat? How many modes? What is ui? I've scoured the thread and kickstarter but I cannot find ui.
 
Last edited:
Anyone know what size rubber boot will fit? I really dislike the metal switch cap. It's very loose and gets caught quite easily.
 
recDNA said:
Thanks for the quick reply! How was heat? How many modes? What is ui? I've scoured the thread and kickstarter but I cannot find ui.
Click to expand...

Full press to switch on and off. You can do like a half press to cycle the brightness modes, though if you switch off and on quickly (within a second or so), then that also cycles the mode (so like a double click I guess). Goes from lowest to highest.

I've got the Eneloop Pro AA back in there now, so take this bit with a grain of salt. Leaving it on the brightest mode, the head section gets warm, but nowhere near uncomfortable. The section where the trits go is a separate piece, so the heat doesn't seem to transfer as effectively down to there, though it still does get warm.

I have noticed that the tail switch is quite sticky on mine. Anyone else have this?
 
Last edited:
Just got it, but there is something wrong with it.

i can't take off the the copper part, and can't install the tritiums.
also, I found a scratch on it.

is it the defective one?
 
jeb said:
I can't take the copper part off
Click to expand...

Stop babbling!

The copper part as you are calling it is supposed to stay in place.

Look at my review pictures. Just the head containing the lens and reflector should be removed.

The tritium is loaded thru the 8 holes. There's enough clearance for either the tritium or stainless steel rods.
 
You must log in or register to reply here.

Latest posts

Back
Top