Spring and insulator for d26/p60 modules

[mesa232323]

Ordered a bunch of blank drop ins for incandescent which include the reflector and and copper base. http://dx.com/p/26-5mm-19-6mm-aluminum-textured-op-reflector-for-xenon-emitters-14879
Where do I source the insulator for keeping positive away from ground and the spring?

The spring and insulator on the right is what I'm looking for

[/URL] IMG_3203 by flashaholic1, on Flickr[/IMG]

 

[mesa232323]

Help would be appreciated

 

[Thr3Evo]

Can you use the ones meant for tail caps? What's the size? Intl outdoor has some for tail caps that look like what youre looking for. Just take off the switch and use the board only. Fasttech also has some in the same way and they are cheap enough that if you throw away the switch you won't feel bad.

 

[__philippe]

Could this be part of what you are after ?

A - Top diameter 6.5mm, base diameter 9mm, height 11mm, line thickness 0.9mm
B - Top diameter 5.5mm, base diameter 8mm, height 11.5mm, line thickness 0.6mm
C - Top diameter 4.5mm, base diameter 7.5mm, height 11mm, line thickness 0.6mm
D - Top diameter 5mm, base diameter 8mm, height 8mm, line thickness 0.8mm
E - Top diameter 4mm, base diameter 8mm, height 3mm, line thickness 0.6mm
F - Top diameter 3.5mm, base diameter 5.5mm, height 2.5mm, line thickness 0.6mm
G - Top diameter 4.5mm, base diameter 10.5mm, height 11mm, line thickness 0.6mm
[Silver plated. Flattens to a height of 0.6mm (down to the line thickness)]

For "insulating gaskets", mouse around http://www.intl-outdoor.com/

Cheers,

__philippe

 

[mesa232323]

The pcb boards from that link was exactly what I was searching for. Thanks a lot :thumbup:

 

[__philippe]

PCB boards like these ? (ø21 mm and ø17mm)