old4570
Flashlight Enthusiast
Chesee PR4 ... Or sourced from China PR4 for 25 Oz Bananas to my door ...
It was so cheap I could not say no ..
I will say , I was expecting a Dog Of A Knife , and I was expecting to complain a lot about it ...
CH-ESEE-PR4
Mystery Steel
65/60HRC ( 65HRC file bites / 60HRC file skates )
Edge from the factory was very FUBAR ..
Sharpened to 18 degrees per side VIA guided system to 1000 grit diamond .
Fail came at 450 slices with a roller fail . ( Deformed apex )
No video - Lost it - Reloaded windows 10 2 times in the last 2 weeks .. ( Trying to control W10 )
Knife is not , not overly comfortable .
I did tune it :
Ground the spine to make it bushcrafty .
Ground the finger guard to make it less vertical . ( Inverting the knife to scrape wood with the spine hurt )
Sheath got a spacer to tighten the knife ( finger guard ground = smaller = slop in the sheath )
The edge still has some FUBAR which may have some bearing on the result .. ? Butt & it's a huge butt ,,, For the bananas .................
