tino_ale
Flashlight Enthusiast
To set the height I face a piece. I start with the tool a tad low, it leaves a nipple artifact at the face center.
I then raise it slightly until the nipple dissapear completely and I get a nice flat center. It seems to be pretty precise.
As I have an ongoing issue with my motor (vibration/noise) I have halted any investigation related to surface finish. Once I get a smooth running motor, I hope the finish will improve!
I then raise it slightly until the nipple dissapear completely and I get a nice flat center. It seems to be pretty precise.
As I have an ongoing issue with my motor (vibration/noise) I have halted any investigation related to surface finish. Once I get a smooth running motor, I hope the finish will improve!
Last edited: