I buy the energizer lithium for my home automation because they last long than any other battery, the Deadbolt locks are a huge drain on the batteries.
im looking at rechargeable AA Li-ION
I search around but i really couldn't find any tests on them here.
Amazon has "USB Rechargeable AA...
I have been thinking about this for while not really sure where to start
my stl-v6 died its an older one that is the regular XM LED from cree
I would like to a XHP70 in place of this, I know ill have to change out hte boards and such, but it should be one monster if I can make it work......
you say the light draw 7amp form the batteries, would a battery rated at 10A work fine then? is it 7 from each battery or 7amp 4 ways ? how are the batteries set up?
i just got the Nitecore EC4S, I thought it would be to big to ECD but man is it light and at 2100L I don't know of a better light, it is also flat rather than round, I have been carrying it for 2-days and i don't even notice its there
is goes all the way down to 2L and 5 steps to 2100
so will the 10A orbtronic work in just about everything? Im looking at the K60 and the review here said it draws 7A from 4 18650, i assume its 2 in || then the pairs in series witch would mean only about 1.5 AMP per battery
hello
So i'm a little rusty on my basic electronics. I have LD75c an I put the Orbtronic 3200 batteries in it. there site says the are rated for a 10 amp draw
with 4 18560 in there I dont see how it could draw more than 5-6 amps from each battery, depending on batt config. witch i think this...