LockedSemaphore
Newly Enlightened
- Joined
- Oct 29, 2018
- Messages
- 10
Hi everyone, I'm new here, and trying my first flashlight build. And just want to make sure I'm going to wire this up right when I put it in my light host (probably a convoy s2+).
i bought the following from mtn electronics:
3 X Nichols 219s (mtn3xp-219c-d420)
qlite 17mm driver 7135*8
18650 Samsung inr
In my (all be it) ghetto wiring, I have light! However it seemed "too easy", so wanted to ensure I wasn't missing anything?
also, when I put the driver and leds in the pill, will I ground both to the pill (thereby grounding on the host/frame)? Subsequently the switch (clicks) on the host will also ground to the frame?
any insight would be greatly appreciated!
thanks in advance!
i bought the following from mtn electronics:
3 X Nichols 219s (mtn3xp-219c-d420)
qlite 17mm driver 7135*8
18650 Samsung inr
In my (all be it) ghetto wiring, I have light! However it seemed "too easy", so wanted to ensure I wasn't missing anything?
also, when I put the driver and leds in the pill, will I ground both to the pill (thereby grounding on the host/frame)? Subsequently the switch (clicks) on the host will also ground to the frame?
any insight would be greatly appreciated!
thanks in advance!