goldserve
Flashlight Enthusiast
I presume you wanted Sammie sized boards and not the 0.6" one for the JIL 1.3W?
You can become a Supporting Member.
goldserve said:You can find lots of pictures from my other posts. The wiring is pretty simple. Led + to the led positive and GND to the LED -'ve. Remember to put some solder on the back of the board for the GND connection. The pad on the top is unconnected by mistake.
moraino said:So, on the chip side, the LED is to led positive and GND is to led negative.
On the back side, put a little wire thru that hole to connect the GND on both side. Am I right?
LumenHound said:The only minor problem I had was in adjusting the strobe frequency. Took me 3 tries to dial it down to 4 hertz and then up to 6 hertz, but after that it was a snap. If you dial it up to 20 hertz it'll put a smile on your face.