Is this the top of the 7135 regulated output?
Great question!
Not always. I just tested two different ceilings, starting with Manual Memory OFF..
IF I set ceiling 10 units lower, the startup output is 160 lumens and that is Not top of 7135. otoh IF I set ceiling 40 steps lower, then yes, the startup output after removing the head is 115 lumens and YES, that IS the top of 7135
iow, the startup output after removing the head, changes depending on what I set the ceiling to... it might or might not turn at at top of 7135.
However, given that your goal is to set manual memory to the top of the 7135, here is a sure way to get there.
1. Set the ceiling 61 steps lower, iow, use 6x long press, plus 1 clic, to lower the ceiling. Ceiling now produces 115 lumens.
And when I test on my Opple, the output is flat, regulated, with NoPWM. iow,YES, that is top of 7135.
2. I set this to manual memory. (10C from On)
3. I then changed the ceiling to 10 levels lower.
Without removing the head, the light still turns on to the Manual Memory and it IS Top of 7135.
And suprisingly, with Manual Memory still set to Top of 7135, removing the head for 10 seconds and then reinstalling it, Also turns on at the Manual Memory output, that is set to top of 7135. (it did not work that way with Manual Memory Off)
I set a manual mode memory of 1 minute
the Temporary Memory Timer is a separate function.. dont confuse it with the Manual Memory setting, which works even when the Temporary Memory timer is set to 0.
I really appreciate the quality of your question, I hope you will now be able to memorize the top of 7135.. Enjoy!