You can become a Supporting Member.
Thanks, this will help alot.
I'll be going with Mountain Electronics for my parts and have couple questions.
For the LED's, I'm looking at going with the XP-L HI U4 4000k. They come pre-soldered in parallel. Is this the way they should be for this build? Or is series better?
For the Driver I'm going with the QLITE REV.A 7135*8 3.04A LED DRIVER - 17mm. I see you can increase the current up to 6 amps. Can the LED's handle the amps? Or the limiting factor is probably the batteries. Can IMR 16340 support that pull? what about IMR 18350?
Thanks for any answers that can be provided.
[h=1][/h]
For a single cell setup, u have to use the parallel configuration..
The triple can definitely take 6A because it will be divided by 3; 2A per emitter..
And yes, pls use a IMR18350 if u are planning to run it at 6A.
Sweet.. Good luck with your build.Thanks for the responses. I'll be ordering my parts very soon.
Also wanted to say thanks to mcbrat for making this happen. Looking forward to returning my Mac to my EDC rotation.
Looks like yes for 18350, no for 16340 - limit to 4A max. on that cell size. Do any Mac EDCs accept 18350 cells?...I see you can increase the current up to 6 amps. Can the LED's handle the amps? Or the limiting factor is probably the batteries. Can IMR 16340 support that pull? what about IMR 18350?
Thanks for any answers that can be provided.
I will take 2 standard and 1 triple conversion. $136 shipped to Canada. I will be away at work (edit) *until tomorrow. I will sent paypal then, if that is ok.
Thank you
Curious, I've got a Ti that runs 16340 and I thought that was the norm. I do wish it ran 18350s...may have to look into getting her bored .