sunny_nites
Enlightened
Great. I'm really glad I saw this thread. I'm sure you'll sell a ton of them.
Thanks!
Sassy little copper G4, fresh off the buffer wheel
Great. I'm really glad I saw this thread. I'm sure you'll sell a ton of them.
The G3s use four stainless steel 2-56 x 3/8" SAE screws. The G4s use eight M2 x 4mm stainless steel metric screws, except for the very first couple off the line that also use the SAE screws.
One note of caution, try not to lift the lid off of the light. The lids are sealed with an extremely thick silicone grease to aid in water resistance. This grease is not like the stuff they use to protect car light bulbs from the elements but is similar to what is used to seal watch stem o-rings on high end watches and such.
I would suggest replacing one screw at a time. Also, the screws are set with low hold Loctite to make sure they never back out or become loose and you would want to use that to seal them as well.
Now with all that being said, getting screws to match the countersink is more complicated than it sounds. Sending you an IM to discuss some options.
Thanks! Hope you enjoy it!Just got my G4 aluminum. What a cool little light.
For sure, I can send you a couple of replacements. One thing to keep in mind; the port covers are ground and tuned per light. The replacements should be pretty close but may not fit exactly like the original.How about the screw that covers the charge port in the G4? I'd like to get a couple of replacements.
Thanks! Hope you enjoy it!
For sure, I can send you a couple of replacements. One thing to keep in mind; the port covers are ground and tuned per light. The replacements should be pretty close but may not fit exactly like the original.
send them with my brass and copper lights
Had a quick question. I just noticed with the light off I can see a faint blue glow from the inside of the light. And it's mostly in back of the left LED. What is that?
Beacon ... ?