Doesn't the post selection depend on and vary with the type of reflector used? I seem to have to vary post-height for the same bulb in regular Mag reflectors, 3" FM reflectors, FM Throwmaster reflectors and to a lesser extent Delghi/Carley 3" reflectors.
I hadn't planned to send posts/screws along with the KIU sockets, figuring I'd just install them as needed. Should I send them anyway?
You are correct. That is why I mentioned either a selection of screws and tubes, or the threads match KIU's which many of us have his pegs. The sample post legs Alan sent me worked fine in a FM-3H with 5761, but Osram bulb was too high. You also have to be careful with the wires if you adjust bulb holder, so you don't break their solder connection as you raise/lower pedestal. Been there, done that with adjusting AWR Hotdriver height.
Last edited: