Update
v5 Triple dropins ready to ship, in XPL red and XPL amber:
http://www.oveready.com/a-engines-h...irty-three-level-drop-in-3500l-/prod_163.html
Already ordered along with the new host [emoji1303]
You can become a Supporting Member.
Update
v5 Triple dropins ready to ship, in XPL red and XPL amber:
http://www.oveready.com/a-engines-h...irty-three-level-drop-in-3500l-/prod_163.html
Already ordered along with the new host [emoji1303]
Can you fit the Walking Wand onto a crenalated bezel?
I am very new to this!
Replacing is good, the v5 will melt the spring through which the z59 passes all current.I plan on replacing the SF Clicky on my C2 with the original Z41 modded with a Torchlab Mcclicky. The question is will I need to replace the stock Z44 bezel with a cooling bezel to run the triple without getting extremely hot? The main thing I'll be using this for is walking the dog morning and night, so I could have it on constantly in a medium mode for more than an hour, with occasional bursts of high mode. Something tells me the light will be uncomfortably hot to the touch if I don't run this thing in a finned head.
Apologies if this has been asked in the thread before; are the support posts for the optic large enough to be drilled for Tritium vials? Has anyone attempted this with one of these drop-ins yet?
I'm not sure what that means... I put the light into programming mode. All seems well. Then I put the light up to the screen and run the optical program. The low red led disappears. I power off the light. Then I power it on at which point the light goes white-red. The white is on for a fraction of a second and the the bright red immediately turns on and stays on.Sorry for the confusion
Flashing white then red indicates 111 voltage pin, programming is the longer 222 pin. Red flashes only.
Sounds like bounce is set to high. PMing instructions...I'm not sure what that means... I put the light into programming mode. All seems well. Then I put the light up to the screen and run the optical program. The low red led disappears. I power off the light. Then I power it on at which point the light goes white-red. The white is on for a fraction of a second and the the bright red immediately turns on and stays on.
What should I do?
I'm not sure what that means... I put the light into programming mode. All seems well. Then I put the light up to the screen and run the optical program. The low red led disappears. I power off the light. Then I power it on at which point the light goes white-red. The white is on for a fraction of a second and the the bright red immediately turns on and stays on.
What should I do?
Sounds like bounce is set to high. PMing instructions...
Did not try that. I will. Thanks1. after you have programmed the light, is the program working?
2. if you have bounce enabled, lower the sensitivity
Good luck
That did it. Thanks!Did not try that. I will. Thanks